Power Fist SF5040 Manuel Du Propriétaire page 7

V 1.40
LOADING & OPERATION
WARNING! Always disconnect the tool from the compressed air before loading. When
loading the tool always point the tool away from yourself and others. Make sure that you
are not holding the tool with trigger depressed while loading the tool.
1. Disconnect the tool from the air supply Grasp the nailer firmly with one hand. Press the latch with your
thumb and pull the magazine back. Insert a strip of fasteners into magazine Keeping it point down.
2. Release the latch and pusher, slide the pusher against the nails until it contacts the nails and lock
into place. The tool is now ready for use.
3. Connect the tool to the air supply. Make sure the air pressure is in the correct range denoted in the
Specifications.
4. Test the driving depth in a sample piece of wood before using. If the fasteners are being driven too
far or not far enough, adjust the regulator to provide less air pressure or more air pressure.
WARNING: Never operate tool unless safety nose is contact with the work piece. Do not
operate tool without fasteners or damage to tool may result. Never fire fasteners into air
because fasteners may injury operator or others and damage to tool may result.
Caution: Check and replace any damaged or worn components in the tool.
1. Attach a high flow pick connect fitting to the tool.
2. Empty the magazine.
3. Connect the tool to an air compressor using the air hose. Ensure the air hose has a working pressure
exceeding 200 PSI and a female quick coupler.
4. Regulate the air pressure to obtain 60 to 100 PSI at the tool.
5. Disconnect the air supply from the tool.
6. Load fasteners into the tool
7. Reconnect the air supply to the tool.
8. Grip tool firmly and hold trigger while pushing the tool firmly against the work service.
MAINTENANCE
WARNING! Disconnect the tool from the air compressor before adjusting, clearing jams,
servicing & maintenance, relocating and during non operation.
CLEARING A JAMMED FASTENER
1. Disconnect air tool from air hose
2. Pull back the pusher until it latches at the end of the magazine.
3. Remove jammed fastener.
4. Press the latch button and slide the pusher forward.
For any technical questions, please call 1-800-665-8685
7
8042509