Air Source - Power Fist SF5040 Manuel Du Propriétaire

V 1.40
SERVICE
1. Check for damaged parts. Before using any tool, any part that appears to be damaged should be
carefully checked to determine that it will operate properly and perform its intended functions. Check for
alignment and binding of moving parts, for broken parts or mounting fixtures, or for any other condition
that may affect proper operation. Any part that is damaged should be repaired or replaced by a qualified
technician.
2. When servicing, use only identical replacement parts. Only use accessories intended for use with this
tool. Replace damaged parts immediately.

AIR SOURCE

1. Disconnect air supply. Disconnect tools from air
pressure source when not in use, before cleaning,
servicing or changing a piece or accessory.
After disconnecting, discharge any residual air
pressure.
2. Do not use tools if the trigger switch does
not function properly. Any tool that cannot be
controlled with the ON/OFF switch is dangerous
and must be repaired.
3. Use proper size and type of air pressure line
and fittings. The recommended air line for this
tool is 1/4" NPT air inlet.
4. Always verify prior to using a tool that the
air source has been adjusted to the rated
air pressure or within the rated air-pressure
range. Over pressurizing a tool may cause
bursting, abnormal operation, breakage of the
tool or serious injury to persons. Use only clean,
dry, regulated compressed air at the rated range
as marked on the tool.
5. Never use pure oxygen, carbon dioxide, combustible gases or any bottled gas as an air source for
a tool. Such gases are capable of causing an explosion and serious injury to persons. Do not use an air
source besides an air compressor to power this tool.
6. Always use an air regulator, an in-line filter and a moisture trap in your compressed air system.
These accessories will increase the tool's life and keeps the tool in good working condition. See the
diagram above for recommended components of an air line.
7. Drain the air tank daily. Water in the air line will damage the tool.
8. Clean air inlet filter weekly.
9. Avoid using an unnecessarily long air hose. Choose a hose that is appropriate for the situation, as a
hose that is too long and running across the floor can be more dangerous than helpful.
10. Keep hose away from heat, oil and sharp edges. Check hose for wear, and make certain that all
connections are secure.
11. Always carry a tool by its handle, never carry the tool by the air hose.
12. Line pressure should be increased to compensate for unusually long air hoses (over 8 metres). The
hose diameter should be 3/8" l.D.
13. Air tool CFM consumption ratings are based upon a 25% duty cycle. If you require continuous duty,
a larger compressor will be required (eg. 4.0 CFM tool at continuous duty requires 16.0 CFM to function
at maximum torque).
For any technical questions, please call 1-800-665-8685
4
8042509