ECOVACS ROBOTICS DEEBOT OZMO 960 Manuel D'instructions page 29

No. Malfunction
DEEBOT misses cleaning spots
7 to be cleaned, or repeats
cleaning the area cleaned.
DEEBOT is making too much
8
noise when cleaning.
AIVI Visual Detection Sensor
9
cannot recognize objects.
Possible Causes
The cleaning cycle is interfered by small
objects or barriers on the floor.
DEEBOT is working on slippery polished
floors.
DEEBOT is unable to reach certain areas
blocked by furniture or barriers.
The LDS is blocked.
DEEBOT is tangled or blocked with debris.
The cleaning area is not well illuminated.
AIVI Visual Detection Sensor lens is dirty or
blocked.
6. Troubleshooting
Solutions
Remove power cords and small objects from the floor
to ensure cleaning efficiency. DEEBOT will automatically
clean the area missed, please avoid moving DEEBOT
manually or block the path during the cleaning cycle.
Make sure the floor wax is dried before DEEBOT starts
cleaning.
Tidy up the area to be cleaned by putting furniture and
small objects in their proper place.
Remove the objects that are blocking the LDS.
Clean DEEBOT as described in section 4 Maintenance
and restart. If the trouble persists, please contact
Customer Care.
AIVI Smart Recognition requires sufficient lighting. Please
make sure the areas to be cleaned are well illuminated.
Clean the lens with a clean soft cloth, and make sure the
sensor is not blocked.
29
EN