Xerox Phaser 6200 Guide De Support page 24

Fiches de sécurité du matériel (en anglais uniquement)
SECTION 8 - EXPOSURE CONTROL - PERSONAL PROTECTION
No special personal protection indicated, when used as intended in Xerox Phaser® color printers.
3
THRESHOLD LIMIT VALUE (TLV): 10 mg/m (total dust)
3 3
PERMISSIBLE EXPOSURE LIMIT (PEL): 15 mg/m (total dust); 5 mg/m (respirable dust)
SHORT TERM EXPOSURE LIMIT (STEL): None established
CEILING LIMIT: None established
3 3
XEROX EXPOSURE LIMIT (XEL): 2.5 mg/m (total dust); 0.4 mg/m (respirable dust)
SECTION 9 - PHYSICAL AND CHEMICAL PROPERTIES
APPEARANCE/ODOR: Black, blue, red, or yellow powders/faint odor
BOILING POINT: Not applicable
SOLUBILITY IN WATER: Insoluble to negligible.
EVAPORATION RATE: Not applicable
VAPOR DENSITY (Air = 1): Not applicable
VOLATILE (%): Not applicable
SOFTENING RANGE: Not available
MELTING POINT: Not available
SPECIFIC GRAVITY (Water = 1): Not available
VAPOR PRESSURE (mm Hg): Not applicable
pH: Not applicable
SECTION 10 - STABILITY AND REACTIVITY
STABILITY: Stable.
INCOMPATIBILITY WITH OTHER MATERIALS: Strong oxidizers
HAZARDOUS POLYMERIZATION: Will not occur
HAZARDOUS DECOMPOSITION PRODUCTS: During a fire, toxic gases may be generated by thermal
decomposition or combustion.
SECTION 11 - TOXICOLOGICAL INFORMATION
This material has been evaluated by Xerox Corporation. The toxicity data noted below is based on test results of the
materials described herein or similar toners.
Oral LD : >5 g/kg (rats), practically non-toxic
50
Dermal LD : > 5 g/kg (rabbits), practically non-toxic
50
Inhalation LC : > 5 mg/l (rats; 4 hour exposure), practically non-toxic
50
Eye Irritation: Not an irritant
Skin sensitization: Not a sensitizer
Skin irritation: Not an irritant
Mutagenicity: No mutagenicity detected in Ames assay
Carcinogens: None present
Imprimante couleur laser Phaser® 6200 21