Table des Matières
Publicité
Déclaration de conformité
Declaration of incorporation
according to the EU Machinery Directive 2006/42/EC, Annex II 1. B
for partly completed machinery
Manufacturer
TROX GmbH
Heinrich-Trox-Platz
DE - 47504 Neukirchen-Vluyn
Description and identification of the partly completed machinery
Product / Article
Type
Function
It is declared that the following essential requirements of the Machinery Directive 2006/42/EC have been fulfilled:
It is also declared that the relevant technical documentation has been compiled in accordance with part B of Annex VII.
It is expressly declared that the machinery the partly completed machinery fulfils all relevant provisions of the
following EU Directives or Regulations:
2006/42/EC
2014/30/EU
2014/35/EU
Reference to the harmonised standards used, as referred to in Article 7 (2):
EN ISO 12100:2010-11
The manufacturer or his authorised representative undertake to transmit, in response to a reasoned request by the national authorities, relevant
information on the partly completed machinery. This transmission takes place
by post
This does not affect the intellectual property rights!
Important note! The partly completed machinery must not be put into service until the final machinery into which it is to be incorporated
has been declared in conformity with the provisions of this Directive, where appropriate.
Neukirchen-Vluyn, 11.08.2017
34
VAV controller
TVR, TVJ, TVT, TZ/TA-Silenzio, TVZ/TVA, TVM, TVRK, TVLK, LVC
Controller for flow and / or pressure control in ventilation systems
Directive 2006/42/EC of the European Parliament and of the Council of 17 May 2006 on machinery,
and amending Directive 95/16/EC (recast) (1)
Directive 2014/30/EU of the European Parliament and of the Council of 26 February 2014 on the
harmonisation of the laws of the Member States relating to electromagnetic compatibility (recast)
Directive 2014/35/EU of the European Parliament and of the Council of 26 February 2014 on the
harmonisation of the laws of the Member States relating to the making available on the market of
electrical equipment designed for use within certain voltage limits
Safety of machinery - General principles for design - Risk assessment and risk reduction (ISO
12100:2010)
Unités terminales à débit variable VARYCONTROL
Person established in the Community authorised to
compile the relevant technical documentation
Jan Heymann, TROX GmbH
Heymann Jan
CE-Beauftragter
Page 1/1
Publicité
Table des Matières
