Tools Required For Installation; Important - Husky LIGNE CENTRALE FS Instructions De Montage, D'installation Et D'utilisation

Masquer les pouces

Table des Matières

Les langues disponibles

These instructions are guidelines only. Actual installation is the responsibility of the installer and the

owner. Always measure truck and trailer before installing hitch to be sure that there is clearance at the

The following list of tools will be needed for proper installation of all components:

•

Safety Glasses

•

15/16" Open End Wrench (5/8" HEX NUT)

•

1-1/8" Box End Wrench (3/4" HEX HEAD BOLTS)

•

1-1/16" Socket (3/4" HEX NUTS)

•

3/4" Socket (1/2" HEX NUTS)

•

½" Ratchet

•

Measuring Tape

•

Torque Wrench capable of 380 ft-lbs. of torque

•

1-7/8" Thin-Walled Socket (1-1/4" HITCH BALL NUT) – REQUIRED ONLY IF REMOVING OR

TIGHTENING THE HITCH BALL

Recommended tools for installing the Hitch Ball:

None are required as the hitch ball comes from the factory pre-installed. It is recommended that you

check the torque of the hitch ball nut periodically using a 1-7/8" Thin-walled socket depending on hitch

ball size.

Torque Wrench capable of 380 ft-lbs. of torque (always check ball manufacturer's specifications for

proper torque rating)

Before installing or towing with this Bolt Together Weight Distributing Hitch please read and

follow all instructions and warnings in the tow vehicle owner's manual and trailer owner's

Have gross trailer weight and tongue weight checked before selecting and installing any weight

Weigh trailer again after fully loading and check loaded tongue and gross weight to ensure

This kit is to ONLY be used with Husky weight distribution spring bars only that are designed for

this particular system. Do not substitute with any other spring bars.

All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information / Tech Support /

WARNING

bumper to allow for turns.