Husky LIGNE CENTRALE FS Instructions De Montage, D'installation Et D'utilisation page 8

10. Put a ¾" flat washer on the top ¾" hex bolt followed by a ¾" nylon lock nut. Put a ¾" flat
washer on the bottom 3/4" hex bolt followed by a ¾" nylon lock nut. Torque the ¾" nylon
lock nuts to 260 ft-lbs.
ILLUSTRATION 11
¾ Nylon Lock Nut
¾ Flat Washer
11. Insert a spring bar into the tube. Secure with the "D"-pin. Swing wire "D" around the tube
and over the end of the pin. Repeat for the other side.
BE SURE THAT THE "D" RETAINING PIN GOES THROUGH GROOVE IN THE SPRING
BAR. PULL DOWN ON SPRING BARS TO TEST FOR PROPER ATTACHMENT.
ILLUSTRATION 12
Spring Bar
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information / Tech Support /
Product Updates. 2023 Keystone Automotive Operations Inc. All Rights Reserved. 2023-Rev4
"D"-Pin
Page-8