Husky LIGNE CENTRALE FS Instructions De Montage, D'installation Et D'utilisation page 13

Spring bar loading on lift brackets
27. To load the spring bar onto the lift bracket, orient the lift tool as shown below and come under the
spring bar. Then, put the "finger" of the lift tool into the square hole on the lift bracket and using
BOTH hands on the lift tool. Lift firmly and then rotate and push the lift tool towards the trailer
until the spring bar is resting completely on the lift bracket and off the 2 pins. If it is too difficult
to lift the spring bar, then raise the height of the trailer until the spring bar is closer to the spring
bar support surface of the lift bracket.
ILLUSTRATION 19
All Products limited to Vehicle Tow Rating, see Vehicle Owners Manual. Visit www.huskytow.com for Warranty Information / Tech Support /
Product Updates. 2023 Keystone Automotive Operations Inc. All Rights Reserved. 2023-Rev4 Page-13