General Information - Hayward SWIMCLEAR C100SE Guide De L'utilisateur

GENERAL INFORMATION

The SwimClear™ filters are high performance swimming pool filters with a residential filtration rating of up to 30 m
Manufactured from durable, corrosion-proof material, they are designed for continuous or intermittent operation, for
installation above or below the pool water line, for fresh or saltwater swimming pools or spas. SwimClear™ filters utilize a
reusable single element, reinforced polyester filter cartridge to provide a high degree of water clarity with absolute minimum
care. Their unique design is such that no tools are needed to remove or replace the cartridge in the filter assembly. Simply
unscrew the lock ring, lift off the filter head and remove the cartridge. It's that easy.
PUMP SELECTION AND LOCATION
To power your SwimClear™ filter, select a continuous duty pump designed for swimming pool or spa service. It is important
to first determine where your pump and filter will be located. If above the water line, a self-priming pump must be used.
Self-priming pumps such as Hayward's Max-Flo XL™, Super Pump
level and prime automatically.
Select a pump appropriate for your application. Take into consideration: operation of hydrotherapy fittings, automatic
cleaners, required turnover rates and losses in the system. A dealer can help you select the proper size pump for your
system.
INSTALLATION
⚠
WARNING
– This product should be installed and serviced only by a qualified pool professional.
1. Since plumbing fittings offer a resistance to water flow, position the filter as close to the swimming pool as local codes
allow. Keep the number of fittings to a minimum. Select a well-drained area, one that will not flood when it rains.
2. Set the filter on a solid level surface. Allow a minimum clearance above the body for cartridge removal of 305 mm for
the C100SE and allow 381 mm for the C150SE and allow 457 mm for the C200SE. Observe minimum side clearance
requirements for the filter, and pump (see fig.3). Locate drain, air relief and pressure gauge for convenient operation and
viewing.
3. Position the filter to allow for proper drainage.
4. If practical, place pump and filter in the shade to shield it from direct heat from the sun.
Filter Location
Pressure
BELOW water Line
Gauge
Lock Ring
Return to pool
Page 4 of 7
Pool Suction
Figure 1
USE ONLY HAYWARD GENUINE REPLACEMENT PARTS
®
, or TriStar
Filter Location
ABOVE water Line
Lock Ring
Return to pool
SwimClear™
®
have the ability to lift water from a lower
Pressure Gauge
Figure 2
3
/h.
Pool Suction
Rev. A