STEP 4
On the Right Divider (E) insert 6 each Cam Lock (3) in
the hole position shown on the drawing. When inserting
the cam lock make sure that the arrow is facing toward
the cam screw entry.
STEP 5
On the Right Side Panel (C) insert with a Rubber Mallet
or Hammer 7 each Wooden Dowel (6). Tap securely
into place
On the Right Side Panel (C) insert 7 each Cam Screw
(1) into the position shown on the drawing with a
Phillips Screw Driver.
On the Right Side Panel (C) insert 2 each Cam Lock (3)
in the position shown on the drawing. When inserting
the cam lock make sure that the arrow is facing toward
the cam screw entry.
On the Right Side Panel (C) install 2 each Hinge (8)
with 2 each Middle Screw (13) per hinge. NOTE: Only
install the small hinge plate as the hinge assembly will
be connected to the door in the next step.
STEP 6
On the Door Panel (J) install the 2 each Hinge (8) with
4 each Middle Screw (13) and a Phillips Screw Driver.
On the Door Panel (J) install the Lock (7) with 4 each
Large Screw (14) and a Phillips Screw Driver. Note:
The "O" Ring goes on the opposite side of the door to
secure the lock into position.
LLR60126_64850_Manual.indd 5
LLR60126_64850_Manual.indd 5
Right Divider
C
Right Side Panel
13
J
Door Panel
(back side)
8
3
E
Panel
6
3
1
13
8
14
J
Door Panel
(front side)
7
"O" Ring
PAGE 5 OF 27
3/4/11 5:22 PM
3/4/11 5:22 PM