Festo SBO Q Serie Notice Simplifiee page 26

4.3 Trigger signal
The trigger signal is applied via the input I0.
The trigger condition is fulfilled when a 1 signal (edge)
is detected at I0.
The trigger signal is for starting the evaluation of an
inspection part using the compact camera.
As long as evaluation is in progress, the C LED is off and
a 0 signal is applied to output O0.
Note
The signal levels/edges of the input I0 can be
configured via system parameters. The given descrip
tion corresponds to the standard configuration.
Note
Additional information on operating the Compact Vision
System can be found in the CheckKon help system.
26 Festo P.BE−K−SBO−Q 0809b English