Power Fist 9073925 Mode D'emploi page 8

9073925
POWER CORD SAFETY
1. Insert the power cord plug directly to the power supply whenever
possible. Use extension cords or surge protectors only when the tool's
power cord cannot reach a power supply from the work area.
a. When operating a tool outside, use an outdoor extension cord
marked W-A or W. These cords are rated for outdoor use and reduce
the risk of electric shock.
2. Do not operate this tool if the power cord is frayed, damaged or poorly
spliced, as an electric shock may occur, resulting in personal injury or
property damage.
3. Discontinue use if a power cord feels more than comfortably warm while
operating the tool.
4. Keep all connections dry and off the ground to reduce the risk of electric
shock. Do not touch the plug or wiring with wet hands.
5. Prevent damage to the power cord by observing the following:
a. Place the power cord in a position that prevents it from coming into
contact with the tool or getting caught by the workpiece. The cord
should always stay behind the tool.
b. Do not pull on the cord to disconnect the plug from an outlet.
c. Keep the cord away from heat, oil, sharp edges or moving parts.
6. Position the cord so it is not be stepped on, tripped over or otherwise
subjected to damage or stress.
7. Do not wrap the cord around the tool, as sharp edges may cut insulation
or cause cracks if wound too tight. Gently coil cord and either hang on a
hook or fasten with a device to keep cord together during storage.
KICKBACK PRECAUTIONS
Kickback is a sudden reaction whensnags or is caught on the material. If
kickback occurs:
• The sanding drum may pass over a body part, causing a seriously injury
• The tool may strike bystanders.
• Kickback can also damage the tool or workpiece.
Kickback can be avoided by taking proper precautions:
www.princessauto.com / 1-800-665-8685
VARIABLE-SPEED ELECTRIC DRUM SANDER/POLISHER V1.0
Page 8