Power Fist 9073925 Mode D'emploi page 6

9073925
POWER TOOL PRECAUTIONS
1. Do not use any power tool with a malfunctioning power switch or control.
A power tool that fails to respond to the controls is dangerous and can
cause an injury. A qualified technician must repair and verify the power
tool is operating correctly, before it can be used.
2. Shut the power off and disconnect the drum sander from the power
supply (if possible) before making any adjustments, changing accessories,
cleaning, servicing or when storing. Such preventive safety measures
reduce the risk of starting the tool accidentally.
3. Never force the tool. Excessive pressure could bend or break the drum
sander, resulting in damage to the tool, your workpiece or serious
personal injury. If the drum sander runs smoothly under no load, but
does not run smoothly under load, then excessive pressure is being used.
4. Check if the drum sander's moving parts are misaligned or binding before
each use. Correct the issue before using the drum sander to avoid an
injury or damage to the tool.
5. Always be aware of the position of your hands relative to the drum
sander. Avoid awkward hand positions where a sudden slip could cause a
hand to move into the sanding drum. Never reach behind or beneath the
drum sander.
6. Only use accessories that are specifically designed for use with the drum
sander. Ensure the sanding drum is tightly installed.
7. Only use a sanding drum that exceeds the Speed rating (see
Specifications).
8. Before using the drum sander on a workpiece, test the drum sander by
running it at the highest speed rating for at least 30 seconds in a safe
position. Stop immediately if there is any abnormal vibration or wobbling.
Check the tool to determine the cause.
9. Never touch the sanding drum or workpiece during or immediately after
use. They may be hot and could inflict a burn injury.
10. The material and the motor housing can get very hot during operation.
Stop work until the tool cools down to a safe temperature.
11. Do not cover the air vents. Proper cooling of the motor is necessary to
ensure normal life of the tool.
www.princessauto.com / 1-800-665-8685
VARIABLE-SPEED ELECTRIC DRUM SANDER/POLISHER V1.0
Page 6