Connect Water Line To House Shutoff Valve; Connect Drain Hose - Maytag MDB4949SHZ Instructions D'installation

CONNECT WATER LINE TO HOUSE
SHUT-OFF VALVE
NOTE: If using a flexible braided hose, replace inlet hose
after 5 years to reduce the risk of hose failure. Record
hose installation or replacement dates on the hose for
future reference.
58.
Attach water supply line
Attach the water supply line (copper tubing or flexible braided
line) to the hot water line using a connection configuration that
is in compliance with local codes and ordinances. The water
supply to the dishwasher should have a manual shut-off valve
located under the sink.

CONNECT DRAIN HOSE

59.
Connect drain hose
Connect drain hose to waste tee or waste disposer
using one of the following options:
Option A: Waste disposer – no air gap
■
Option B: No waste disposer – no air gap
■
Option C: Waste disposer – with air gap
■
Option D: No waste disposer – with air gap
■
IMPORTANT: The drain hose connection of the disposer
or a waste tee must be made before the drain trap and at
least 20" (508 mm) above the floor where the dishwasher
will be installed.
Helpful Tip: To reduce vibration of the hose, keep the
hose away from the floor.
22
Option A: Waste disposer – no air gap
Disposer inlet
Helpful Tip: Remove disposer knockout plug.
1. Using a hammer and screwdriver, knock
1
plug into disposer.
2. Use needle-nose pliers to remove plug.
2
3. Attach drain hose to disposer inlet with
3
large drain hose clamp (provided). Use
pliers to squeeze clamp open and move
into position.
Large drain
hose clamp
Drain hose
Drain trap