Changing Indicator Settings With Data Link; Auto Power Down - Tru-Test S3 Guide De Démarrage Rapide

1. Open the MiHub Data Link mobile app and connect to the indicator.
2. Select to open Settings, and choose Span Calibration.
3. Start the wizard and follow the steps to complete the span calibration.
Changing indicator settings with
4
Data Link
You may want to change the indicator settings depending your weighing scenario.
MiHub Data Link for mobile makes this a quick and simple process.

Auto power down

By default, the indicator will power down after 15 minutes of inactivity, unless it is
plugged in and charging.
On Indicator powers down after 15 minutes of inactivity
Off Indicator remains powered on until battery runs out, or it is powered off
manually
The default Auto power down setting is On.
Auto zero
Auto zero promotes rapid weighing between animals, and removes the need to press
the Zero button after each animal has been weighed.
On Rapid weighing between animals is enabled
Off Press zero after each animal is weighed
The default Auto zero setting is On.
You may want to remove Auto Zero if you're weighing grain or produce that
takes time to come to full weight on the load bars.
7