Operation - Royal Sovereign ARP-2208 Mode D'emploi

STEP 5: Attach the hose connector to the exhaust air outlet of unit.
STEP 6: Adjust the length of the flexible exhaust hose. Avoid bends in the hose and ensure that the unit
is near the electrical outlet.

OPERATION

BEFORE PLUGGING IN THE UNIT TO A POWER SOURCE:
1. Let the unit stand upright for a minimum of 2 hours. This will reduce the chance of malfunction in the
cooling system.
2. Ensure the rubber drain plugs are securely plugged into the drain ports on the back of the unit to
prevent any possible water leaks.
3. Ensure the exhaust hose and window kit installation has been installed properly and properly vented.
Conduct a Power Plug Check:
1. Press the RESET button on the power cord.
2. Plug the cord into an electrical outlet.
3. Press the TEST button on the power cord. The RESET button should pop up.
4. Press the RESET button for use.
5. Do not use the air conditioner if the test fails.
NOTE:
1. If you turn the air conditioner off and immediately restart it, allow up to 3 minutes for the
compressor to restart cooling. In the event of a power failure, wait 3 minutes before restarting
the unit.
2. The unit sold in the United States is preset to Fahrenheit. the unit sold in Canada is preset to Celsius.
-9
-
ARP-2208