Royal Sovereign ARP-2208 Mode D'emploi page 13

ARP-2208
SAFETY PRECAUTIONS, MAINTENANCE AND CONTINUOUS DRAINAGE
Automatic Defrost
As a safety precaution, this unit is equipped with Automatic Defrost Feature. At low room temperatures,
frost may buildup at the evaporator during operation. To ensure ideal operation of the unit, the units built
in Automatic defrost function will activate. the air conditioner unit will automatically start defrosting and
the POWER LED will blink.
The auto defrost feature will operate in cooling setting. When in cooling operation, if the unit ambient
temperature sensor senses the evaporator coil temperature to be below -1°C, the compressor will stop
operating for 10 minutes. When the coil temperature sensor detect 7 °C, the unit will restart to cool
operating mode.
Overload Protection
In the event of a power loss, to protect the compressor there is a 3-minute delay until the compressor
restarts.
Drainage (Dehumidfying)
Built into this unit is self-evaporating drainage feature. Under normal operating conditions, the
self-evaporative feature of the unit will operate without issue or maintenance being required. However,
in high humidity conditions, you may need to drain manually water from the unit. (Ft error) You may also
choose to do continuous drain option, which would drain water automatically from the unit.
(in dehumidifier mode)
To Drain Manually
1. Turn off the power to the unit and unplug
2. Place a water tray under the drainage port at the bottom of the unit to collect water
3. Remove the rubber drainage plug and allow water to drain
4. Replace the plug, when drainage water stops flowing
For continuous drainage into a floor drain
To operate similar to a stand alone dehumidifier, you may choose to use continuous drain option:
• Turn off the power to the unit and unplug the unit.
• Remove the plug of the water outlet opening.
• Attach the drain hose. Ensure that the hose is straight without any knots and clear of obstruction.
• Place the other end of the drainage hose into a floor drain.
• Replace the rubber sealing plug after operation to prevent leaks.
-13
-