GBC StreamWire Manuel D'instructions Et D'utilisation page 9

Step 9: Secure the spool by
using the spool retainer. Turn the
knob clockwise to thread the cap
into the spindle until spool is
secure. Do not over tighten.
Step 10: Gently remove the flat
cardboard spacer that is used to
secure the wire during shipment.
Before removing the spacer,
check that the flexible magnet is
installed to secure the wire.
Step 11: Pull the wire and paper
away from the spool and hold
them both in one hand. With your
free hand install the wire shield.
Step 12: While still holding the
carrier paper, use the magnetic
catch to hold the wire.
Step 13: Lift the metal guide of
the shield and slide the carrier
paper between it and the lower
bars.
Step 14: Attach the end of the
carrier paper to the rewind spool.
Leave 1-2in (2.5-5cm) of excess
and fold that back on top of the
metal clip.
Step 15: Turn the rewind spool
clockwise until you have enough
wire to reach the blue wire guide.
Slide the wire onto the plastic
wire guide and feed it into the
plastic sprocket. Use the knob to
manually turn the
sprocket and aid wire installation.
Step 16: Adjust the wire end
position by using the knob
attached to the wire
sprocket. The wire end should
line up in the window on the
blade guard. The wire end
should line up with the transition
line between the blue wire guide
and the grey anvil.
Step 17: Proper installation of
the spool is shown. Wire loose
end is fed around the guide and
positioned properly on the wire
feed sprocket. Paper loose end
is secured to the paper feed hub.
Once installed properly, rotate
the paper rewind spool clock-
wise until the wire makes contact
with the sensor flap under the
spool.
Step 18: Slide the wire feeder drawer back into the machine.
Ensure that the drawer is pushed fully back or the message "Push
Feeder In" will appear on the LCD
Step 19: Close the wire feeder door.
9
StreamWire
plastic
feed
GB