GBC StreamWire Manuel D'instructions Et D'utilisation page 6

5. STREAMWIRE DIES
Prior to Operation of the StreamWire, a StreamWire die set must be
installed into the StreamPunch Ultra. StreamWire will not function
unless one of the die sets listed below is installed.
Die Set Details
A die set from the following list must be used. Refer to Section 10 of this
document for further details.
Die, eWire, 3:1, Round
Die, eWire, 3:1, Square
Punched Hole Quality
Prior to operating the StreamWire for the first time, or whenever a die
set is changed, perform the hole quality check outlined in Section 9 B.
6. QUICK START GUIDE
StreamWire must be connected to AC power and the rear ON/OFF
switch should be ON to enable any feature of the machine.
 A spool of the correct size twin loop wire must be installed before
running a bind job. See Section 7 B for details on loading twin
loop spools into the StreamWire
 Ensure that the book drawer in area 4 is set to the size paper
you intend to use, shown below.
 Check that the StreamPunch Ultra has a StreamWire die as
detailed in Section 5.
When binding is not directed the machine will operate in bypass mode.
NOTE: The GBC StreamWire cannot be used to bind books using
manual scan mode.
DOWN
Layout of StreamWire LCD User Interface
404772
404770
UP
ENTER
7. USER OPERATIONS
A. Removing Supply Spool from the Machine:
Supply spools can be removed from the machine before they are
empty to be stored for future use.
B. Installing a New Supply Spool into the Machine:
StreamWire offers a variety of different twin loop wire options,
depending on the requirements of your job. Load a new wire supply
spool if a different size or color of binding is required, or when the
spool is empty.
C. Supply Spool Storage:
The twin loop wire supply spools should always be stored
according to the guidelines listed to prevent damage.
D. Emptying the Book Drawer:
Empty the book drawer to remove your bound books.
E. Clearing Jams:
How to clear paper or wire jams.
6
StreamWire
GB