Brita PURITY Quell ST Mode D'emploi page 33

6.1 Removing the Filter Cartridge
• Switch off power supply to the terminal device (remove plug).
•
Close inlet valve
• Place the flushing hose in a bucket and remove pressure from the filter system by opening the
flush valve. Catch the escaping water in a bucket.
Note: If the escaping water is more than 1 litre, the inlet valve
blocked with scale.
•
•
Place the pressure vessel lid
Note: Do not turn the lid horizontally on its head.
•
Stand on the kick loops
the mantle handles
•
Take your feet off the kick loops
the mantle handles
•
Remove exhausted filter cartridge
•
Place the exhausted filter cartridge
remaining water (> 5 min.).
•
Lock the exhausted filter cartridge
cartridge and return in the original packaging to the appropriate BRITA address listed on the
back of the cover.
6.2 Inserting the Filter Cartridge
•
•
•
•
•
•
•
Switch on power supply to the terminal device (plug).
•
To flush and bleed the new filter cartridge
at inlet hose .
7 6
Stand on the kick loops
lid by pressing the lock
3
vertically on both lid handles
3
with both feet while turning the pressure vessel
12
as far as it will go.
16
and press the pressure vessel
12
.
16
from the pressure vessel
2
in the sink with the connection facing down to drain the
2
with the transport protective cap
2
Check the connector seat of the filter cartridge O-ring
lid for dirt and damage.
1
Check that the O-ring seal of the filter cartridge
groove and also check for dirt and damage.
Note: The cartridge seat has been lubricated with food-safe lubricant at the
factory.
Place the new filter cartridge
Stand on the kick loops
clockwise until the mantle handle
Stand on the kick loops
lid on the pressure vessel
3
lid handle must line up with the "INSERT" groove.
20
Press the pressure vessel lid
engages.
7
with both feet while opening the pressure vessel
12
and turning it anticlockwise as far as it will go.
15
.
20
in the pressure vessel
2
with both feet, lift the pressure vessel
12
is over the kick loops
16
with both feet and place the pressure vessel
12
. The positioning of the arrow marking on the
1
down and turn clockwise until the lock
3
carry out the steps described under 5.3.
2
is not completely closed or is
anticlockwise by
1
down with both hands on
1
.
1
of the new filter
18
in the pressure vessel
2
is correctly seated in the
2
.
1
turning it
1
.
12
EN
15
29