Optika Italy IM-3F Manuel D'instructions page 8

Installing the color filters
► Remove the filter holder, then install the
color filters you need. (Fig.11, Fig.12)
Mount the color filter flat as shown in ①,
verifying that they are not tilted.
► If the color filter is tilted or otherwise
②
out of place , it may fall.
②
The color filters can be stacked in the
holder. This allows to install as many filters
as needed, as long as the whole thickness
is less than 11 mm.
Installing the fluorescence
• Pull the black plastic cover out, from the
microscope rear. (Fig.13)
• Insert the lens/diaphragm assembly from
the back. In order to ease the insertion,
just tilt the assembly at about 45° and
move it forward. Fix it using the 3 provided
allen screws. (Fig.14)
• Insert the lamp house and fix it with the al-
len screw (already inside the support tube
(1) ). (Fig.15)
All manuals and user guides at all-guides.com
①
Page 8
Fig.11
Fig.12
Fig.13
Fig.14
Fig.15