Rivacold BEST W R290 Notice D'instructions page 124

3. Remove the front panel [D].
4. If necessary, lower the controller panel [E].
5. If necessary, remove the top panel [E].
7.6 Checking or replacing condensing unit components
7.6.1 Required skills
Mechanical maintenance engineer
7.6.2 When to check or replace
Perform this procedure when problems are found on the condensing unit components (see "Installation and
operation troubleshooting" on page 129).
7.6.3 Warning
Check or replace the components following the instructions, frequency and all indications in this manual and
in the attached documentation. If necessary, contact RIVACOLD srl assistance.
7.6.4 Checking or replacing internal components of the condensing unit
Instruction manual v. 00 | 9600-0033
Rev.
BEST W R290
1. Remove the side panels [A].
2. Remove the front panel [B] and lower the
3. Check or replace the internal components of
4. Set all the panels in place again.
© 2020 RIVACOLD srl
|
controller panel [C] and if necessary, remove
the top panel [D] (see "Remove the front panel"
on the previous page).
the condensing unit.
EN
7. Maintenance
123