Rivacold BEST W R290 Notice D'instructions page 105

EN
5. Installation
5.5.2 Dimensions of the window to be made in the wall
Depending on the dimensions of the packaged unit, cut a window with the following dimensions in the
coldroom wall. Use the packaging template to proceed more quickly.
BEW25 Codes
5.5.3 Procedure
1. On the wall of the refrigeration coldroom, make a
window [A] using the template in the packaging.
4. Place the plug-in insulating panel [E] between the
brackets of the packaged unit.
5. Insert the tube of the tray [B] with the gasket [F]
together with the screws [G] into the plug-in
insulating panel.
NOTICE: pay attention to the correct positioning of the drain
heater.
104
BEST W R290
BEW30 Codes
2. Unscrew the tray screws [B] and remove it from
the evaporating part [C], paying attention to
the drain heater.
3. Apply the gaskets [D] supplied with the plug-in
insulating panel kit.
6. Secure the plug-in insulating panel [E] and the
tray [B] to the packaged unit.
Instruction manual
BEW35 Codes
v. 00 | 9600-0033 © 2020 RIVACOLD srl
Rev. |