Rivacold BEST W R290 Notice D'instructions page 102

Position the packaged unit so that there is sufficient space to pick it up, lift it and move it safely.
l
Place the packaged unit indoors and covered with sheets so as to avoid exposure to atmospheric
l
agents.
Place the packaged unit on a stable, solid supporting surface with characteristics so as to withstand the
l
weight of the packaged unit and the equipment involved
Place the packaged unit in an environment with specific temperature and humidity conditions
l
See "Technical features" on page 146 for more information.
5.3 Installation requirements
5.3.1 Stability requirements
Check that the wall where the packaged unit is to be installed is suitable for supporting it.
5.3.2 Requirements for the connection to the electrical mains
The packaged unit is supplied with a power lead and plug.
Comply with the following requirements:
The voltage and frequency supplied must correspond to those indicated on the identification plate
l
Insert a differential circuit breaker (RCD) between the power line and the packaged unit, adequately sized
l
for the application and the laws in force in the country of installation. The switch must be near the
packaged unit.
See "Technical features" on page 146.
5.4 Install the BEST WS (saddle)
5.4.1 Result of the installation
5.4.2 Dimensions of the grooves to be made in the wall
Depending on the dimensions of the packaged unit, make two grooves on the upper end of the coldroom
wall. Use the packaging template to proceed more quickly.
BEWS25 Codes
Instruction manual v. 00 | 9600-0033
Rev.
BEST W R290
BEWS30 Codes
© 2020 RIVACOLD srl
|
5. Installation
BEWS35 Codes
101
EN