Defrosting, Cleaning And Maintenance - Nordcap M150 Mode D'emploi

GB

Defrosting, cleaning and maintenance

Automatic defrosting.
The unit is defrosted automatically. Defrost
water runs through a pipe and is collected
in a tray above the compressor where the
heat generated by the compressor causes it
to evaporate. The defrost water tray should
be cleaned at intervals.
Cleaning.
Before cleaning the appliance, unplug it
from the main supply. The cabinet is best
cleaned using warm water (max. 65°C) with
a little mild detergent. Never use cleaning
agents that scour. Use a soft cloth. Rinse
with clean water and dry thoroughly.
The defrost water channel, in which
condensation from the evaporator runs, is
located at the bottom of the rear inside wall
of the cabinet and must be kept clean. Add
a few drops of disinfectant, e.g. Rodalon,
to the defrost water drain a couple of times
a year, and clean the drain using a pipe
cleaner or similar. Never use sharp or
pointed implements.
The sealing strip around the door must be
cleaned regularly to prevent discolouration
and prolong service life. Use clean water.
After cleaning the sealing strip, check that it
continues to provide a tight seal.
Dust collecting on the condenser on the
rear of the cabinet, the compressor and
in the compressor compartment is best
removed using a vacuum cleaner.
16