Defrost; Maintenance - Nordcap M1 Mode D'emploi

4.4 - Defrost

The cabinet defrost automatically. When this process starts the sign
switches itself off automatically.
Should it be necessary (excessive ice in the evaporator), it is possible to carry out a further defrosting process (besides those
already programmed). In order to do this press button
programmed is re-established.
It is advisable that following defrosting the doors are not opened so as to allow the temperature level to be reached more rapidly.
Defrosting water go into a tray underneath the cooling unit, where they are automatically evaporated (in models that do not
evaporate automatically, this tray should be emptied regularly).
4.5 - Cleanliness
In order to ensure perfect hygiene and conservation, it is recommended that the following regular and daily cleaning procedures
are adhered to:
 Careful and regular cleaning of the surfaces using a damp cloth.
 A neutral detergent and water should be used, totally avoiding those which are chlorine-based or are abrasive.
 Wash down with pure water and dry with care.
 The use of water-pressure jets is not recommended, in particular in the direction of the compressor.
 Cleaning of the drainage tables is recommended and verification of the existence or not of items or residue which may obstruct
the flow of the condensation water.

4.6 - Maintenance

In order to ensure long life and correct operation of the refrigeration system, regular maintenance of the condensation should be
carried out, as follows:
 Disconnect the cupboard from the electric current, by taking out the plug.
 Vacuum or lightly brush the condensation, according to the track direction.
4.7 - Prolonged lack of Use
When prolonged periods with lack of use are predicted, the following measures are recommended:

Disconnect the cabinet from the electric current;

Remove completely the food produce;
 Carry out any maintenance operations;
 Leave the doors slightly open so to avoid odours.
4.8 - Irregularities
Should any irregularities in the operation be detected, before calling the technical services, ensure that:
 The main switch is lit;
 The doors close correctly;
 See themselves the magnetic electric switches from the door are it they function well.
 The equipment is not placed near to any heat source;
 The condenser is clean and the ventilator motor is operational;
 There is not too much ice in the evaporator.
Should these inspections be negative, it is advisable to remove what is placed within the cabinet, disconnect it from the electricity
network and request assistance from the nearest technical services available.
Note: Maintenance should be carried out by specialised technicians and the use of non-original parts allow that the manufacturer
withdraws any responsibility and cancels the guarantee.
TMPF55A.TMP
TEC
INSTRUCTIONS MANUAL
lights up. Following the deferring process the same sign
for a period of 5 seconds; at the end of this further cycle the timetable
N.º
TMPF55A.TMP
12/40