SCANGRIP Canvik One Instructions D'utilisation page 6

Long Springs
•
Use the included extension units for compressing long springs. The
maximum distance is increased by fitting the extension units with
the 4 special bolts included.
It is very important for your safety that the extension units
and jaws are fitted correctly and that the bolts are firmly
tightened before use.
Conical Springs
•
Use the included extension unit to ensure that the centre line of the
spring is parallel to the compressing device. Do not use the coil
spring compressor for conical springs if this is not the case. Fit the
extension unit with included bolt in order to raise the jaw at the
spring end with the smallest diameter.
It is very important for your safety that the extension unit
and the jaws are fitted correctly and that the bolts are firmly
tightened before use.
Ball Springs
•
Use the included extension units to ensure that the centre line of
the spring is parallel to the compressing device. Do not use the coil
spring compressor for ball springs if this is not the case. Raise both
jaws by fitting the extension units with the 2 bolts included.
It is very important for your safety that the extension units
and the jaws are fitted correctly ant that the bolts are firmly
tightened before use.
Long Springs Conical Springs Ball Springs