SCANGRIP Canvik One Instructions D'utilisation page 2

Working safely with this tool is possible only when the
operating and safety information are read completely
and the instructions contained therein are strictly fol-
lowed.
•
Before each use, check the unit for full functional capability. If the
functional capability is not ensured or if damage is detected, the
unit should not be used.
•
When compressing the spring, neither the spring windings nor the
jaws should come in contact with each other, Fig.B
•
The centre line of the spring must always be parallel to the com-
pressing device, especially for conical springs.
•
Use only suitable jaws for the springs. The spring must rest se-
curely within the outer rib and the safety ridges. Take care that slid-
ing of the spring out of the jaws is not possible.
•
The bolts of the jaws must always be firmly tightened.
•
When using impact wrench do not exceed 180 Nm torque limit.
•
For repair, use only original parts.
•
Do not make any construction changes to the unit. Do not replace
safety pin by a stronger safety pin.
Use as intended
The coil spring compressor is exclusively for compressing and expanding of
McPherson strut springs whereby suitable jaws must be used. Any other or
further use is considered not as intended.
For Your Safety