LawnMaster VBRM16 Manuel D'instructions page 23

OPERATION
Cutting Modes
Auto Cutting
In Auto cutting mode, the robotic mower will mow the lawn in a random pattern.
After the robotic mower is powered on, press the Auto Mow Button for 2 seconds. Then press
the START/ON Button. After 5 seconds of continuous running, you will hear beeps to indicate the
blades have started to spin.
The robotic lawnmower will automatically search for a suitable working area. If the robotic mower
does not find grass within 5 seconds, it will change direction and start running again in a new
direction. The blades will not spin until the mower can run for continuously for at least 5 seconds.
Spot Cutting
In spot cutting mode, the robotic mower will mow in a spiral outwards from where it is placed on
the lawn. This is best used to tidy up any areas that may not have been mowed during a random
mowing session.
After the robotic mower is powered on, press the Spot Cutting Button for 2 seconds. Then press
the START/ON Button. The mower will first move forward about 10 to 20 cm, then start spot cutting
covering approximately 2 square metres. After the spot cut is finished, the robotic mower will start
to mow in a random pattern automatically.
If the area to be mowed is too narrow for the robotic mower to carry out the spot cut, after
continuous searching, the mower will mow in a random pattern automatically.
NOTE: Spot cutting is also a great feature to use before random mowing to systematically and
efficiently cut the main areas of the lawn, by doing this it reduces the amount of random cutting
time needed to complete the lawn. You also get a better lawn finish.
Setting the Cutting Height (See Fig. 17)
WARNING
Do not make any adjustment to the lawn mower without first stopping the motor. Keep your feet
away from the blade disc when adjusting its height.
The cutting height of the mower can be adjusted from MIN (20 mm) to MAX (60 mm) (Fig. 17).
During the first weeks of mowing, always select the higher cutting height (40 mm). After this, the
cutting height can be lowered step by step every week until the desired cutting height has been
reached.
■ Press the STOP button to stop the robotic lawnmower.
■ Turn the cutting height adjustment knob to set the cutting height.
- Turn clockwise to raise the cutting height.
- Turn anti-clockwise to lower the cutting height.
23