LawnMaster VBRM16 Manuel D'instructions page 32

TROUBLESHOOTING
Grass is being cut
unevenly.
Area of cut (battery
duration) is not large
enough.
The cutting blade is
not rotating while the
mower is switched
on.
Error indicator is
yellow continuous.
Working area is too big.
Blades are dull.
Height of cut is too low, or the
grass is too high.
There is grass wrapped around
the blade disc.
Height of cut is too low, or the
grass is too high.
The grass is wet or damp.
The grass is dense.
The battery is not fully charged.
The lawn area is too large.
The cutting blade is obstructed.
The blade screw is loose.
The lift sensor is activated for 10
seconds.
The obstruction sensor has
tripped 10 times within one
minute.
Adjust the borders/protections to
decrease the size of the mowing area.
Recharge the battery to mow the
area twice or purchase an additional
battery to increase the size of the cut
area.
Replace all the blades and screws.
Refer to Replacing the Mower Blade
section on page 27-28. Visit www.
cleva-europe.com for info on where to
buy blades.
Increase the height of cut.
Check underneath the mower and
clear as necessary (always wear
gardening gloves).
Increase the height of cut.
Wait until the grass is dry.
Increase the height of cut and cut
more frequently.
Charge the battery.
Recharge the battery and mow again
or purchase an additional battery for
extended mowing of larger areas.
Remove the isolator key and the
battery pack. Clear obstruction
(always wear gardening gloves).
Tighten the blade screws.
Remove and re-insert the isolator key.
Check the working area for obstacles
taller than 10 cm and remove them.
Restart the mower.
Remove and re-insert the isolator
key. Remove any obstacles. Check
whether the grass is too tall. If
necessary, mow the grass to below 60
mm with a conventional lawn mower.
Restart the mower.
32