Fitting The Rack; Mounting The Rack; Motor Positioning; Correct Motor Positioning On Rack - BFT IANUS BT 300 Kit Instructions D'utilisation Et D'installation

FITTING THE RACK

After installing the motor, place the rack over the pinion leaving a 2 mm gap�

MOUNTING THE RACK

Secure the rack modules drilling holes through the slots using a 5�5 diameter drill bit and secure the screws� Warning: the rack must be level�
Ø5,5
Close the gate and secure the other rack modules until the entire gate length is covered� Make sure the mechanical stops are installed

MOTOR POSITIONING

210mm
210mm
25
V1
30 6
R1
6,4
CORRECT MOTOR POSITION
ON RACK
Move the motor under the rack and illustrated�
210mm
10 mm
OK
2 mm
The
mechanical
stops must
already be
installed
NO
33
-
IANUS BT 300 KIT - IANUS BT 500 KIT