Loading The Bottom Rack - Thermador DWHD64CP Guide D'entretien Et D'utilisation

Preparing and Loading the Dishware
Cup Shelves
In addition to cups, the cup shelves can also hold
large utensils.
Grasp the cup
shelves as
shown in
Figure 6 and
fold them down.
Place cups
upside-down on
the cup shelves.
Knife Rack
The knife rack is an extra shelf for knives and
other large utensils.
It is assembled onto
an edge of the
upper rack.
Place knives with
sharp sides down,
see Figure 7.

Loading the Bottom Rack

Place large items in the bottom rack. Load pots
and pans upside-down. Figures 8 and 9 show
typical mixed loads for the bottom rack.
Figure 8
Figure 6
Figure 7
(continued)
Figure 9
12 place setting
Bottom Rack Accessories
Flip Tines
Flip Tines fold down to make loading the racks
easier in some instances.
Grasp the
tines as
shown in
Figure 10
and fold the
tines
downward.
Rack Attachment
The rack attachment has two additional cup
shelves upon which to place cups and large
kitchen utensils. The rack attachment is as-
sembled on the rear edge of the lower rack.
To assemble:
Slide the Rack Attachment in Figure 12, keeping
the longest tines on the inside of the top basket
wire (a) and on the outside of the lower basket
wire (b), see Figure 11. The
short tines will snap into
place, see Figure 13.
Figure 11
Rear
corner
a
view of
Rack
inset
b
Figure 10
Figure 12
7