Installation; Positioning The Hobs; Positioning The Oven; Fixing The Hob - ETNA A566ZT Notice D'utilisation

Installation

INSTALLATION AND SETUP SHOULD
GB
BE CARRIED OUT BY AN AUTHORISED
TECHNICIAN IN LINE WITH CURRENT
INSTALLATION STANDARDS.

Positioning the hobs

Depending on the model to be installed, an
opening with the dimensions shown in
figure 1 will be cut into the unit's worktop.
The system for fixing the hob is intended
for use with kitchen units with a thickness
of 20, 30 and 40 mm.
The hobs described in this manual can
only be installed with ETNA oven.
The minimum distance between the surfa-
ce supporting the cooking pans and the
lower part of the kitchen unit or the hood
located above the hob should be 650 mm.
If the hood's installation instructions
recommend that the gap is greater than
this, you should follow this advice.
The unit where the hob and oven will be
located will be suitably fixed.
The glues used in manufacturing
the kitchen unit and in the adhesive on
the decorative laminate of the worktop
surface should be made to tolerate tem-
peratures of up to 100ºC.
ETNA assumes no responsibility
for any malfunction or damage caused
by faulty installation.
During installation, care must be
taken not to break the glass.
PLEASE REMEMBER THAT THE GUA-
RANTEE DOES NOT COVER THE
GLASS IF IT SUFFERS A VIOLENT
BLOW OR IF IT IS USED IMPROPERLY.
14
Important
Minimum distances
to walls
Minimum ventilation
distances
OVEN

Positioning the oven

See the corresponding manual.

Fixing the hob

When the gap has been properly sized,
the sealing washer should be put on the
lower part of the hob. Silicone should not
be applied between the glass and the
unit worktop because if it becomes
necessary to remove the hob from its
position, the glass could break when
trying to detach it.
fig. 1
Fitting
holes