Chiller Fresh System (Some Models); Garden Fresh Crispers (Some Models); Covered Storage Bucket (Some Models) - Amana ART2127AB Manuel De Réparation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Chiller Fresh
System (some models)
Chiller Fresh
system features a drawer inside a sleeve.
Air circulates between drawer and sleeve. This system
keeps food fresh longer and up to 5°F (3°C) colder than
Fresh Food temperature.
Chiller Fresh
control is located below front shelf trim.
Control adjusts amount of air circulating around drawer.
Slide control to cold for normal Fresh Food temperature
and to coldest for colder temperature. Ice crystals may
form on drawer or food on coldest setting. Cold air can
decrease Fresh Food temperature. Fresh Food control
may need to be adjusted.
• Remove drawer by lifting and pulling out. Remove
shelf by lifting front, releasing hooks from metal
track then pulling out.
• Replace shelf by inserting hooks into metal track
and lowering front. Use slots 1 through 3 only.
Replace drawer by sliding in.
When moving Chiller Fresh
control, located on center back wall of Fresh Food
section, to same side as system.
Garden Fresh
Crispers (some models)
Garden Fresh
crispers keep produce fresh longer. Wrap
produce tightly. Do not wash produce before placing in
crispers. Excess moisture could cause produce to spoil
prematurely. Do not line crispers with paper towels.
Paper towels will retain moisture.
Garden Fresh
control is located below front shelf trim.
Control adjusts humidity in crispers. Slide control to high
for produce with leaves such as lettuce, spinach or
cabbage. Slide control to low for produce with skins such
as cauliflower, corn or tomatoes.
Remove shelf and crispers by completing the following
steps.
1. Open left crisper (For doors hinged on left, open
right crisper).
system left or right, move
!
To avoid personal injury or property damage, handle
tempered glass shelves carefully. Shelves may break
suddenly if nicked, scratched, or exposed to sudden
temperature change.
2. Remove shelf (A) by gently pushing up from
underneath. Tilt one end up then pull out.
3. Remove left crisper by lifting front while supporting
underneath then pulling out (For doors hinged on left,
remove right crisper).
4. Remove support post at recess in bottom center of
Fresh Food section.
5. Remove other crisper by sliding to opposite wall. Lift
front while supporting underneath then pull out.
6. Replace crispers and shelf by reversing steps 1–5.

Covered Storage Bucket (some models)

Storage bucket has a lid and removable egg tray. When
tray is removed, bucket will accept items such as a
standard egg carton, ice, etc.
9
CAUTION
A

Publicité

Table des Matières
loading

Table des Matières