To Reverse Doors; To Replace Doors - Amana ART2127AB Manuel De Réparation

3. Remove bottom hinge (A) and shim (C) with
driver. Remove hinge pin (B) . Remove and retain all
round washer shims, if present.
A

To Reverse Doors

Service Notice: Contour Door Models Only
Only a qualified servicer can reverse this door. To have
doors reversed, please call 1-800-843-0304. There is a fee
for this service.
Reverse Hinges
1. Transfer three cabinet plugs from top corner of cabinet to
holes left from top hinge removal.
2. Transfer three 5 / " hex head screws opposite center
16
hinge
area to the holes left by center hinge removal.
3. Transfer all hinges and shims to opposite side of cabinet.
• Replace bottom hinge pin (A) in bottom hinge
bracket (C) in hole (B) outside of cabinet.
A
• Install top hinge screws loosely to allow enough
clearance to reinstall door.
IMPORTANT: To avoid damage to interior finish, remove
buckets and shelves from freezer and refrigerator door
before continuing door reversal. Lay doors interior-side
down on carpet, or a table or floor protected with blankets or
towels.
Remove Door Stop
1. Unscrew 2 Phillips screws and remove door stop (A) from
refrigerator and freezer door. Retain all screws for door
stop replacement.
A
Reverse Handles(side-mounted design)
To reverse handles on contour model, see service notice at
top of page.
Reverse Handles(front-mounted design)
1. Remove plug (A) from top side of freezer door, and
remove hole plug (B) .
3 / " hex nut
8
B
C
B
C
2. To remove handle (D) , remove 2 Phillips mounting
screws (C) on top edge of freezer door. Remove 2
Phillips screws (E) from handle on underside of freezer
door.
3. Transfer handle (D) to opposite side of door and secure
with four screws from previous step.
4. Insert plug (A) and hole plug (B) into holes on top of door.
B
C
D
5. Remove plug (F) and hole plug (G) from top, and 1
plug (H) from face of door opposite refrigerator handle.
6. Remove Phillips screw (I) from base of refrigerator
handle. Grip bottom trim piece (J) and twist slightly to
one side until trim snaps loose.
7. Remove Phillips screw (K) at base of remainder of
refrigerator handle (M) . Remove 2 Phillips screws (L) from
top of handle (H) .
8. Transfer handle (M) to opposite side of door and secure
with screws from previous step. Trim piece (J) snaps back
into place. Insert screw (I) at base of trim and fasten to
door.
9. Insert plug and hole plug (F&G) into holes on top of door.
L
M
K
J
I
Reverse Door Stops
1. Mount door stop opposite handle side on underside of
door.

To Replace Doors

1. Place refrigerator door on bottom hinge pin. Install
center hinge pin in center hinge bracket. Place round
washer shims(some models) and door closure on center
hinge pin.
4
A
E
G
F
H