Garden Fresh Tm Crisper; Chiller Fresh Tm System (Some Models) - Amana BC21VC Mode D'emploi

TM
Garden Fresh Crispers
TM
Garden Fresh crispers keep produce fresh longer. Wrap
produce tightly. Do not wash produce before placing in
crispers. Excess moisture could cause produce to spoil
prematurely. Do not line crispers with paper towels. Paper
towels retain moisture.
TM
Garden Fresh crisper control is located below front shelf
trim. Control adjusts humidity in crisper drawers. Slide
control to high for produce with leaves such as lettuce,
spinach or cabbage. Slide control to low for produce with
skins such as cauliflower, corn or tomatoes.
Remove shelf and crisper drawers by completing the
following steps:
1. Open left crisper.
• For doors hinged on left, open right crisper.
!
CAUTION
Handle tempered glass shelves carefully to avoid personal
injury or property damage. Shelves may break suddenly if
nicked, scratched, or exposed to sudden temperature
change.
2. Remove glass crisper top by gently pushing up from
underneath. Tilt one end up and pull out.
A Glass crisper top
3. Remove left crisper by lifting from front while
supporting underneath and pulling out. For doors
hinged on left, remove right crisper.
4. Remove support post at recess in bottom center of
Fresh Food section.
5. Remove other crisper by sliding to opposite wall. Lift
from front while supporting underneath and pull out.
6. Replace crispers and shelf by performing steps 2–5
in reverse order.
Chiller Fresh TM System (some models)
The Chiller Fresh TM System features a drawer inside a
sleeve. Freezer air circulates between drawer and sleeve.
This systems keeps food fresh longer and up to 5°F (3°C)
colder than refrigerator temperature.
Chiller Fresh TM control is located below front shelf
trim.Control adjusts amount of air circulating around
drawer. Slide control to COLD for normal refrigerator
temperature and to COLDER for colder temperature. Ice
crystals may form on drawer or food on COLDER setting.
Cold air entering the Chiller Fresh
refrigerator temperature. Fresh Food control may need to
A
TM
drawer can decrease
be adjusted to a lower number to compensate for colder
air.
Chiller Fresh TM drawer can be moved from the left to the
right side of the refrigerator compartment to accomodate
different storage needs. To move drawer perform the
following steps:
1. Remove drawer by lifting and pulling out. Remove
shelf by lifting from front, releasing hooks from metal
track, then pulling out.
2. Remove plastic cap from back wall of Fresh Food
section by placing a knife covered with masking tape
underneath cap and pulling forward.
3. Rotate boot 180° to opposite side.
4. Insert plastic cap in opposite side of Fresh Food
section. Confirm cap is snugly in place. Cold air
may cause food to freeze if cap is not replaced.
5. Replace shelf by inserting hooks into metal track and
lowering the front. Use slots 4 though 6 only.
6. Replace drawer by sliding in. Make sure boot fits
snugly over air inlet in back wall.
1
E
2
E
1 Chiller Fresh System installed on left side of refrig-
erator.
2 Chiller Fresh System installed on right side of refrig-
erator.
A Air inlet
B Boot
9
A
B
D
A
C
B
C Plastic cap
D Metal rack
C