Valor Linear Serie Instructions D'installation page 3

10.
Holding the two sections, slide one rear anchor
behind the screw at the top of the sections where
they meet as indicated and tighten the screw to
secure it.
Note: For 1825RGL, tighten the screws of the
panel anchors through the square holes in
the top rail.
11.
Add the remaining rear anchor to the other two rear
sections.
Because our policy is one of constant development and improvement, details may vary slightly from those given in this publication.
190 – 2255 Dollarton Highway, North Vancouver, B.C., CANADA V7H 3B1
All manuals and user guides at all-guides.com
12.
Designed and Manufactured by / for
Miles Industries Ltd.
Tel. 604-984-3496 Fax 604-984-0246
www.valorfi replaces.com
The top panel is supplied in two identical sections.
The sections are beveled and the smooth black
'fi re side' is notched at the front and straight at the
back. When installed, the top panel rests on the
front and back rails.
a) Insert one section of the top panel, smooth black
surface down. Push the section on the left side
as far as it will go—there is a stop tab at the left
end of the rails.
b) Insert the second section in the same manner.
Push it against the fi rst section and ensure there
is no gap between the sections.
3