Publicité
Les langues disponibles
Les langues disponibles
• Under contamination level 2 conditions;
• Under over-voltage category II conditions�
*) Between 5 – 30 °C [41 – 86 °F], the unit can be operated at a relative humidity of up to 80 %� At temperatures be-
EN
tween 31 – 40 °C [87�8 – 104 °F], the humidity must decrease proportionally in order to ensure operational readi-
ness (e�g�, at 35 °C [95 °F] = 65 % humidity; at 40 °C [104 °F] = 50 % humidity)� The unit may not be operated at
temperatures above 40 °C [104 °F]�
2.3
Hazard and Warning Information
Only intended for indoor use. The unit is only designed for dry applications and may not be oper-
ated or stored outdoors or under wet conditions.
The unit may only be operated with a power cord equipped with a plug appropriate to the local
power supply.
The unit may only be operated if the information on the nameplate conforms with the specifica-
tions of your local mains power supply.
Regularly inspect connecting lines and hoses (e.g., the power cord) for damage (e.g., kinks,
cracks, porosity) or signs of aging. Units exhibiting damaged connecting lines, hoses, or other de-
fects must be taken out of service immediately.
Always unplug the unit from the wall outlet before beginning any work on the unit's electrical
components.
Do not allow the device to be operated without supervision.
It is the responsibility of the operator that national regulations during operation and regarding a
repeated safety inspection of electrical equipment are complied with. For Germany these are the
regulation 3 by DGUV (German Statutory Accident Insurance) in relation with VDE 0701-0702 (As-
sociation for Electrical, Electronic and Information Technology).
Only spare parts and accessories supplied or authorized by Renfert GmbH may be used with this
product. If other spare parts or accessories are used, this could have a detrimental effect on the
safety of the device, increase the risk of serious injury and lead to damage to the environment or
the device itself.
Information on REACH and SVHC is available on our website www.renfert.com, in the Support ar-
ea.
2.4
Authorised Individuals
Only properly trained individuals may operate and service the Vibrax. Any repairs not specifically de-
scribed in these operating instructions may only be performed by a qualified electrician.
2.5
Liability Exclusion
Renfert GmbH shall be absolved from all claims for damages or warranty if:
• The product is employed for any purposes other than those cited in the operating instructions;
• The product is altered in any way other than those alterations described in the operating in-
structions;
• The product is repaired by other than an authorized facility or if any but Renfert OEM parts are
employed;
• The product continues to be employed, despite obvious safety faults or damage;
• The product is subjected to mechanical impacts or is dropped.
3
Product description
3.1
Operating Elements
Refer to Figures 1 and 2�
(A)
ON switch and oscillation mode switch Coarse/Fine
(B)
Power level switch
(C)
Rubber mat
(D)
Mains connection
(E)
Device fuse
- 4 -
Publicité
