Voting; Voting Configurations - Shure Microflex MXCW Mode D'emploi

Sending Audio from a Shure Device
All AES67 configuration is managed in Dante Controller software. For more information, refer to the Dante Controller user
guide.
1. Open the Shure transmitting device in Dante Controller.
2. Enable AES67.
3. Reboot the Shure device.
4. Create AES67 flows according to the instructions in the Dante Controller user guide.
Receiving Audio from a Device Using a Different Audio Network Protocol
Third-party devices: When the hardware supports SAP, flows are identified in the routing software that the device uses.
Otherwise, to receive an AES67 flow, the AES67 session ID and IP address are required.
Shure devices: The transmitting device must support SAP. In Dante Controller, a transmit device (appears as an IP address)
can be routed like any other Dante device.

Voting

The chairperson controls voting sessions from the conference unit or the voting tab in the chairperson web application view.
Use the web application to customize voting session settings, such as:
• Enter a vote subject that will appear above the voting buttons and results, if desired
• Exclude participants from the voting session, if desired
• Choose 1 of the 6 voting configurations
To start a voting session:
1. Choose a voting configuration.
2. Press Start.
3. A voting screen displays on all conference units, and participants with voting rights can cast their votes using the
touchscreen.
4. Press Stop to end the voting session.

Voting Configurations

In an open vote a participant's selection remains visible and interim vote results are shown.
In a secret vote there is no visible indication of how a participant voted and interim vote results are not shown.
Voting Configuration
2-Button (Open)
2-Button (Secret)
A 2-Button vote allows the participant to select either
"Yes" or "No."
Conference Unit Screen
Shure Incorporated
67/93