Siemens Simatic PC FI25 Bulletin Technique page 9

1.3.1 FCC Approval for USA and Canada
This equipment has been tested and found to comply with the limits for a
Class A digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference when
the equipment is operated in a commercial environment. This equipment ge-
nerates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful inter-
ference to radio communications. Operation of this equipment in a residential
area is likely to cause harmful interference in which case the user will be re-
quired to correct the interference at his own expense.
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful interfe-
rence, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment does not exceed the Class A limits for radiated emissions as
described in the Radio Interference Regulations of the Canadian Department
of Communications.
Le présent appareil numérique n'émet pas de bruits radioélectriques dépas-
sant les limites applicables aux appareils numériques de la Classe A prescri-
tes dans le Réglement sur le brouillage radioélectrique édicté par le Ministère
des Communications du Canada.
Bulletin d'informations techniques PC FI25
C79000-K7077-C81 1-02
Federal Communications Commission
Radio Frequency Interference Statement
Shielded Cables
Modifications
Conditions of Operations
Canadian Notice
Avis Canadien
9