KERN EOC 6K-3 Manuel D'utilisation page 87

Press repeatedly until „BEEP" will be displayed.
Press , the current setting for the acoustic signal will
be shown.
Select desired setting (no, ok, ng) by
Confirm input by
Press ; weighing system is in tolerance weighing
mode. From here evaluation takes place whether the load
is within the two tolerance limits.
Weighing with tolerance range:
Determine the item weight, see chap. 7.11
Tare when using a weighing container.
Put on goods to be weighed, tolerance control is started.
The symbols
within the two tolerance limits.
Load below specified
tolerance
• The tolerance control is not active when the weight is under 20d.
• To delete limits, enter „00000 PCS".
EOC-BA-e-1711
.
.
show whether the load is
Load within specified
tolerance
Load exceeds specified
tolerance
33