Télécharger Imprimer la page

Optika Italy SZ Serie Mode D'emploi page 17

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 125
7.11 Assembling procedure
7.11.1 SZ-A1 / SZ-A6
The mounting of the SZ-A1 and SZ-A6 focusing
systems applies to all bases except SZ-STL1,
SZ-STL2 and SZ-STLX. For the assembling pro-
cedure on these bases, please refer to the speci-
fic section.
1. Place the focusing system on the column and,
once the desired height is reached, tighten the lo-
cking knob ① located on the back of the focusing
system. (Fig. 1)
7.11.2 SZ-ST1
1. Remove the base from its packaging and place it
on a flat surface. The base is already assembled
from the factory and does not require any further
assembly procedure other than that of mounting
the focusing system.
7.11.3 SZ-ST2 / SZ-ST3
1. Install the LED spotlight for incident light as shown
in Fig. 2.
By loosening the fixing screw ② you can change
the angle of inclination of the spotlight to optimize
the illumination on the sample.
2. Insert the cable plug into the socket at the top of
the pillar ③. (Fig. 3)
Page 17
F ig. 1
F
ig. 1
F F ig. 2
ig. 2
F ig. 3
F
ig. 3

Publicité

loading