Toro PowerMax Heavy Duty 1028 OHXE Manuel De L'utilisateur page 7

Setup
1
Installing the Upper Handle
No Parts Required
Procedure
2
Installing the
Wheel-Clutch-Cable Ends
No Parts Required
Procedure
1. Route either the left or right cable end over the
lower handle and insert the cable end into the
hole in the corresponding wheel-clutch lever
(Figure 5).
1. Wheel-clutch lever
Figure 5
2. Remove the nut and washer from the handle,
attach the cable clamp on the cable to the
handle, install the washer and the nut, and
tighten the nut by hand
1. Cable clamp (2)
Important:
the cable clamp is against the handle and
that the cable is routed below the clamp bolt.
The cable must be in a straight line from the
cable clamp to the point where it attaches to
the wheel-clutch lever.
3. Pull the cable jacket down gently until the
wheel-clutch lever is down and the slack is out
g001303
of the cable, then tighten the cable-clamp nut
securely
5
(Figure
Figure 6
Ensure that the curved side of
(Figure 7).
g293415
6).
g001304