Télécharger Imprimer la page

Toro PowerMax Heavy Duty 1028 OHXE Manuel De L'utilisateur page 22

Masquer les pouces Voir aussi pour PowerMax Heavy Duty 1028 OHXE:

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 67
Checking the Engine-Oil Level
Service Interval: Before each use or daily—Check the engine-oil level and add oil if necessary.
Checking and Adjusting the
Skids and Scraper
Service Interval: Yearly—Check the skids and
the scraper and adjust them if
necessary.
Check the skids and the scraper to ensure that the
auger does not contact the paved or gravel surface.
Adjust the skids and the scraper as needed to
compensate for wear.
1.
Check the tire pressure; refer to
Tire Pressure (page
2.
Loosen the nuts that secure both skids to the
auger sides until the skids slide up and down
easily.
Figure 31
1. 3 mm (1/8 inch)
Important:
The auger blades must be
supported above the ground by the skids.
3.
Ensure that the scraper is 3 mm (1/8 inch) above
and parallel to a level surface.
7 Checking the
8).
Note:
If the pavement is cracked, rough, or
uneven, adjust the skids to raise the scraper. For
gravel surfaces, adjust the skids further down to
prevent the machine from picking up rocks.
4.
Move the skids down until they are even with
the ground.
5.
Firmly tighten the nuts that secure both skids
to the auger sides.
Note:
To quickly adjust the skids if they loosen,
support the scraper 3 mm (1/8 inch) off the
pavement, then adjust the skids down to the
pavement.
Note:
If the skids become excessively worn,
you can turn them over and set the unused side
toward the pavement.
g001570
20
g257528

Publicité

loading

Ce manuel est également adapté pour:

38855