ABC Design Cobra Instructions De Service page 9

1. Opening the pushchair
a.
Release the transportation lock.
b.
Pull the handle on the stroller (1) upwards until the frame clicks into place (2).
WARNING: Ensure that all the catches are engaged before use.
2. Fitting the wheels
a.
Fit the rear wheels in the slots until they engage firmly.
b.
To remove the wheels, press the button on the rear axle down to release the wheel.
The wheel can then be removed from the axle.
c.
Insert the front wheel in the slot until it clicks into place.
d.
To remove the front wheel, push the button forwards and take the wheel off.
3. Front wheel locking and swivel settings
a.
Push the lever down to lock the front wheel.
b.
Push the lever up to set the wheels in swivel position.
4. Operating the brake
Press the lever down to engage the brake.
Press the lever up to disengage the brake.
5. Attaching and converting the seat
a.
Attach the seat by placing it on the frame until it clicks into place.
Make sure that the seat is properly engaged!
b.
To convert the seat, press the catches up and lift up the seat.
6. Fitting and removing the guard rail
a.
Fit the guard rail by inserting it in the plastic mounts on both sides.
b.
To remove the guard rail from the pushchair, press in the buttons on both sides and pull the guard rail
off away from the pushchair.
7. Adjusting the leg rest
To adjust the leg rest, press in the buttons on both sides and then adjust the height.
Let go of the buttons again so that the leg rest clicks into place.
EN - 06