ABC Design Cobra Instructions De Service page 10

8. Fastening the harness
a.
To fasten the harness, bring the top two plastic catches together and interlock them.
b.
Then insert the interlocked catches into the bottom part of the fastening.
Adjust the harness to a setting where the baby is held in the correct position.
9. Unfastening the harness
To open the harness, press the button on the side.
WARNING: Always use the shoulder harness and lap belt together.
10. Adjusting the backrest
To adjust the seat unit, pull the retainer on the rear of the backrest upwards and then adjust the height of
the seat. When you have reached the required position, let go of the retainer to allow the seat to remain
in that position.
11. Adjusting the handle
Push the button upwards to adjust the height of the handle.
When the handle is at the required height, let go of the button again so that the handle will remain locked
in this position.
12. Folding the pushchair
To fold the pushchair, bring the handle to its lowest position as described in point 19, holding the button
(1) down as you do so.
Now rotate the knob (2) to the left and push the handle down.
Now you can fold up the pushchair.
Note: To unfold the pushchair, follow the instructions in point 1 "Opening the pushchair".
WARNING: Ensure that all the catches are engaged before use.
Carrycot
13. Opening the carrycot
Lift the side panels of the carrier.
Extend and secure the side panels by pushing the two retainers outwards into the mountings.
Make sure that the retainers are securely engaged.
14. Attaching the cot bumper
Lay the bumper in the cot, folding the top part over the edge of the carrycot.
Fasten the press studs and close the Velcro fastenings on the sides.
15. Attaching the hood to the cot bumper
Fasten the press studs on the bottom of the hood onto the bumper.
EN - 07