Worx WX530 Mode D'emploi page 12

**Voltage measured without workload. Initial
battery voltage reaches maximum of 20 volts.
Nominal voltage is 18 volts.
NOISE INFORMATION
A weighted sound pressure
A weighted sound power
K &K
pA wA
Wear ear protection
VIBRATION INFORMATION
Vibration total values (triax vector sum)
determined according to EN 62841:
Vibration
emission value:
The declared vibration total value and the declared
noise emission value have been measured in
accordance with a standard test method and may be
12
used for comparing one tool with another.
The declared vibration total value and the declared
noise emission value may also be used in a
preliminary assessment of exposure.
WARNING: The vibration and noise
emissions during actual use of the power tool
can differ from the declared value depending on the
ways in which the tool is used especially what kind
of workpiece is processed dependant on the
following examples and other variations on how the
tool is used:
How the tool is used and the materials being cut or
drilled.
The tool being in good condition and well
maintained.
The use of the correct accessory for the tool and
ensuring it is sharp and in good condition.
The tightness of the grip on the handles and if any
anti vibration and noise accessories are used.
And the tool is being used as intended by its design
and these instructions.
This tool may cause hand-arm vibration
syndrome if its use is not adequately
managed.
WARNING: To be accurate, an estimation of
exposure level in the actual conditions of use
should also take account of all parts of the operating
cycle such as the times when the tool is switched off
and when it is running idle but not actually doing
Cordless Circular Saw
L = 82.8 dB(A)
pA
L = 93.8 dB(A)
wA
Cutting wood: a = 6.572 m/s
h, W
Uncertainty K = 1.5 m/s²
the job. This may significantly reduce the exposure
level over the total working period.
Helping to minimise your vibration and noise
exposure risk.
Always use sharp chisels, drills and blades.
Maintain this tool in accordance with these
instructions and keep well lubricated (where
appropriate).
If the tool is to be used regularly then invest in anti
vibration and noise accessories.
Plan your work schedule to spread any high
vibration tool use across a number of days.
3 dB(A)
ACCESSORIES
Carbide tipped
blade
Vacuum adapter
Hex key
2
Battery pack
(WA3551.1)
Battery pack
(WA3553)
Charger (WA3860)
We recommend that you purchase your accessories
from the same store that sold you the tool. Refer to
the accessory packaging for further details. Store
personnel can assist you and offer advice.
OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The tool is intended for ripping and cross-cutting
wood and other materials in straight cutting lines,
while resting firmly on the work piece.
ASSEMBLY AND OPERATION
BEFORE OPERATION
Removing and installing the battery
pack
Charging the battery back
Checking the battery charge condition
(only for WX530.1)
ASSEMBLY
WX530 WX530.1
1 1
1 1
1 1
1 /
/ 1
1 1
ACTION
WX530.9
1
1
1
/
/
/
FIGURE
See Fig. A1
See Fig. A2
See Fig. A3
EN