Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
FINAL SETUP
Remove any final packaging materials, and protective film from all exterior areas. Check the electrical
requirements for the correct electrical supply and that the rangetop is properly grounded.
Check power at the junction box wires using a voltmeter having a range of 0-250 VAC.
EN
• A 240 Volt supply should read 220 to 240 Volts between the black and red wires (Line to Line).
• A 208 Volt supply should read 190 to 208 Volts between the black and red wires.
Before testing operation of the appliance, verify electrical power has been restored to the unit.
NOTICE
FUNCTIONAL TEST
FUNCTIONAL TEST
1. Fill an induction-capable cooking utensil with 1/2 - 1" [1.2-2.5 cm] of water and place it on one of
the cooking zones.
2. Switch the control ON by touching the [ON OFF] key(1).
•
If the commands are locked, touch the lock key (10) for a few seconds. The lock is deactivated
and the controls should respond.
3. Touch the zone select key (5) for the cook zone where the utensil is.
4. Touch the power slider and set it to a level between 3 and 9.
5. Observe that the display responds to the power setting, and observe that the cooking utensil
begins to heat up.
6. Touch the selector key (5) for that zone to turn it off.
7. Touch the [ON OFF] key to turn the rangetop off.
1
ON/OFF
2
Power slider - minimum power
3
Power slider - maximum power
4
Power Booster (P)
5
Cooking Zone displays
6
Timer display and + / - setting keys
CRITERIA
CRITERIA
If the controls respond as described and the utensil heats up, then the test is successful.
10
©2021 Hestan Commercial Corporation
9
10
11
12
2
3 4
USER INTERFACE
6
1
5
7
Timer clock indicator (for each zone)
8
Selection indicator dot
9
Pause / Recall Function
10
Key Lock Function
11
Chef Cook Function
12
Warming Function
7
8
Publicité
Table des Matières
