Grundig GKNE268E40 FXN Manuel De L'utilisateur page 10

3. Installation
Refer to the nearest Authorised
Service Agent for installation of
the product. To make the product
ready for use, make sure that
the electricity installation is
appropriate before calling the
Authorised Service Agent. If not,
call a qualified electrician to have
any necessary arrangements
carried out.
Preparation of the
location and electrical
C
installation at the place
of installation is under
customer's responsibility.
Product must not be
plugged in during
B
installation. Otherwise,
there is the risk of death
or serious injury!
WARNING:
and electrical connections
of the product must
be carried out by the
B
Authorised Service Agent.
Manufacturer shall not be
held liable for damages
that may arise from
procedures carried out by
unauthorised persons.
WARNING:
installation, visually
check if the product has
A
any defects on it. If so,
do not have it installed.
Damaged products cause
risks for your safety.
Make sure that the power
cable is not pinched or
C
crushed while pushing
the product into its place
after installation or
cleaning procedures.
3.1 Appropriate
•
•
Installation
•
•
Prior to
•
•
installation location
WARNING:
of the room where the
product will be placed
is too small for the
A
product to pass, then the
product's doors must be
removed and the product
must be turned aside to
pass it through.
Choose a place at where
you would use the product
comfortably.
Install the product at least 30
cm away from heat sources
such as hobs, ovens, heater
cores and stoves and at least 5
cm away from electrical ovens.
Product must not be subjected
to direct sun light and kept in
humid places after installation.
Appropriate air ventilation must
be provided around your product
in order to achieve an efficient
operation. If the product is to be
placed in a recess in the wall,
pay attention to leave at least 5
cm distance with the ceiling and
side walls.
Do not place the product on
the materials such as rugs or
carpets.
Place the product on an even
floor surface to prevent jolts.
Your product can operate in
ambinet temperatures between
-5°C to +43°C.
If two coolers are to be
installed side by side,
C
there should be at least
4 cm distance between
them.
If the door
DA
SV
NO
FIN
11