Franke FTU 3805 XS CYLINDRA E LED0 Mode D'emploi Et Installation page 8

Air Outlet Connection - Ducting Version
When installing the Ducting version, join the Hood to
the outlet duct using a rigid or flexible pipe ø 150 or
120 mm, selection of which is at the discretion of the
installation technician. The pipe may come out of the
hood either at the top or at the back.
REAR OUTLET
• Remember that when drilling the ducting opening
you must follow the diagram provided in the
paragraph on drilling the wall.
• To connect using a ø120 mm pipe, insert the
reduction Flange 9 onto the Hood canopy outlet.
• Fasten the pipe using suitable pipe clamps. The
materials required to do so are not provided.
• Remove any Activated charcoal filters.
TOP OUTLET
• To connect using a ø 150 mm pipe, connect the Hood
to the outlet duct using a rigid or flexible pipe.
• To connect using a ø120 mm pipe, insert the
reduction Flange 9 onto the Hood canopy outlet.
• Connect the Hood to the outlet duct using a rigid or
flexible pipe.
• Fasten the pipe using suitable pipe clamps. The
materials required to do so are not provided.
• Remove any Activated charcoal filters.
AIR OUTLET – RECIRCULATION VERSION
• Insert the PVC pipe 7 provided onto the Hood
canopy outlet.
• Push the pipe all the way in.
EN
ø 150 ø 120
9
ø 150
7
8
8